Allied Telesis AT-WA1104G-10 - Manual (Page 19)

Features in 291-08 19
Version 291-10
C613-10488-00 REV G
CR00017518 ISAKMP 2 The router or switch sometimes could not establish a VPN when the remote
peer was behind a NAT gateway and the router or switch’s remote ID was
set to default.
This issue has been resolved.
Y Y Y Y Y Y - - - - -
CR00017634 PPP 2 If a PPPoE AC service had been added, but AC mode had not been enabled
by using the enable ppp ac command, PADI frames were processed
anyway, potentially leading to a reboot.
This issue has been resolved.
Y Y Y Y Y Y - - Y Y Y
CR00017659 TTY 2 Previously, it was not possible to configure a TTY service on the router (by
using commands like create service).
This issue has been resolved.
Y - Y - - - - - - - -
CR00017662 Core 2 Stopping and restarting two fans on the switch in a particular order could
put the fan fault detection mechanism into a state in which the system LED
would not flash for a fan fault.
This issue has been resolved.
- - - - Y - - - - - -
CR00017724 IGMP 2 When the switch had a hardware filter configured that would match and
discard a received IGMP packet, IGMP snooping still processed the packet
and added the details to its snooping database.
This issue has been resolved.
- - - Y Y Y Y Y - - -
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
Rap
ier w
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800