Allied Telesis AT-WA1104G-10 - Manual (Page 27)

Features in 291-08 27
Version 291-10
C613-10488-00 REV G
CR00011438 Ping 3 When the router or switch pinged a host whose hostname consisted only
of the digits 0-9 and the letters A-F, it treated the given hostname as a
hexadecimal IPX address even if the hostname was in the host list.
This issue has been resolved. Now, when the router or switch pings a host
using a hostname, it checks the hostname in the host list first. If it does not
find the host in the host list, then it treats the hostname as an IPX address.
Y Y Y Y Y Y Y Y Y Y Y
CR00011824 Firewall 3 When a firewall UDP session starts up, the session timeout should be 5
minutes for the first 5 packets of the session, then change to the configured
UDP session timeout value. Previously, the timeout changed after the 6th
UDP packet belonging to that session, instead of after the 5th packet.
This issue has been resolved.
Y Y Y Y Y Y - - - - Y
CR00012066 IP Gateway 3 The command show ip cassi command is obsolete but was still available.
This issue has been resolved. The command has been removed from the
command line. To obtain the same information, use the command show
conf dyn=ip.
Y Y Y Y Y Y Y Y Y Y Y
CR00012168 Classifier 3 Output of the show classifier command displayed only the hexadecimal
protocol value for IP SNAP, instead of also displaying the protocol name.
This issue has been resolved. The output now displays:
0000000800 (IP SNAP)
Y Y Y Y Y Y Y Y Y Y Y
CR00012885 OSPF, GUI 3 If there were virtual OSPF interfaces, then the OSPF Interfaces GUI page
showed all interfaces as belonging to the backbone area (0.0.0.0).
This issue has been resolved.
Y Y Y Y - Y Y Y - Y Y
CR00013352 STP 3 The help displayed by the command set stp port=all ? listed some
parameters twice.
This issue has been resolved.
- - - Y Y Y Y Y Y Y Y
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
Rap
ier w
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800