Fairbanks 1129 SERIES Dual Platform Counting Scale - Manual (Page 28)

Section 4: User Operations
08/12 28 51300 Rev. 1
4.5.5. Setup Piece Weight by Sampling (Re-sample)
If the Piece Weight and Total Weight have not been cleared, weight can be added
or removed, then the key can be pressed to calculate the piece weight again.
EXAMPLE
1. Place a one pound (1 lb) test weight on the scale weighing pan.
2. Press to set this as the number of Pieces.
– It displays on the second line.
3. Press .
– Displays the Piece Weight on the second line.
– Displays the Piece Count on the third line.
4. Press again to use Piece Count number five (5) to sample again.
4.5.6. Auto Re-sample Operation
After a successful sampling operation, the scale will automatically sample again on
the main scale for any new small weight.
– Placing new weight onto the scale will automatically sample again.
EXAMPLE
1. Press to into sample mode.
2. Press to set item number as fifty (50).
– This displays on the third line.
3. Place a five pound (5 lb.) test weight on the scale weighing pan.
– Wait for five (5) seconds after the weight is stable.
– The piece weight displays 0.1, and piece count displays 50.
4. Place a one pound (1 lb) test weight on the scale weighing pan.
– After stabilizing, the scale will re-sample.
Note: The new small weight should be less than half of the sampling weight.
The item change must be greater than five (5).
If the weight change is larger than half of the sampling weight, Auto Re-
sample will stop.
The Auto Re-sample function can be disabled in SETUP SETTINGS menu.