Fairbanks 1129 SERIES Dual Platform Counting Scale - Manual (Page 16)

Section 3: Assembly
08/12 16 51300 Rev. 1
3.3. MOUNTING BRACKET KIT ASSEMBLY, CONTINUED
9. Place the two (2) washers on the Pillar Bolts, install the nuts on the Pillar Bolts,
then tighten the nuts to pull the whole assembly together.
10. On the bottom back-side of the scale’s base, lift up the Lever End ( #34 ) while
placing the hook under the lever's pivot.
– Do this while holding the top of the Beam Load Rod assembly.
11. Insert the “S” Hook ( #3 ) into the eye on the end of the Load Cell Linkage Cable
Assembly ( A ). Insert the hook end of the Beam Load Rod Assembly into the
other end of the “S” Hook ( B ).
NOTE: The lower-end of the Beam Load Rod Assembly must be properly
hooked into the Transverse Lever Pivot .
This can be verified by reaching under the pillar and verifying the hook and pivot
connection.
12. Route the load cell cable through the cable clamps and pull all excess load cell
cable through the slot in the side of the bracket.