Section 3: installation, Tools required, Wheel and pillar assembly – Fairbanks 1129 SERIES Dual Platform Counting Scale User Manual
Page 13
08/12
13
51300 Rev. 1
Section 3: Installation
3.1. TOOLS REQUIRED
#1 or Small Slotted Screwdriver
#2 Phillips Screwdriver
10" Adjustable Wrench
Pliers
3.2. WHEEL AND PILLAR ASSEMBLY
6. Set the Scale Base Assembly (
#4
) sideways on the floor.
7. Insert a Cotter Pin (
#17
) through the small hole in one end of the First Axle
(
#19
).
8. Place a Flat Washer (
#18
) and a Wheel (
#16
) onto the open end of the axle.
9. Insert the axle's other end through both holes in the base.
10. Place the Second Wheel (
#16
) onto the axle.
11. Place a Flat Washer (
#18
) over the axle, and then insert a cotter pin (
#17
)
through the axle’s small hole.
12. Repeat steps 2-6 for the second axle.
13. With the Scale Base Assembly (
#4
) in an upside-down position, center the axles
in the base.
14. Insert the Locking Screws (
#15
) into the tapped holes in the bottom of the base,
tightening the axle into place with the screws.
– Directly under the axle holes.
15. Secure the Lock Nuts (
#14
).
NOTE:
See the diagram on the following page to identify parts in these assembly
instructions.