FEC AFC1200 User Manual

Page 41

Text mode
Original mode

)(& ,QF

4.9.4 Nutrunner (tool) connection

{ Connect the encoder cable, the motor cable and the transducer (sensor) cable to the

corresponding numbered tool. Ensure that the cable tag numbers match the tool tag
numbers.

{ Affix the preamp to the enclosure frame as shown in the following diagrams.

{ Ensure that the cable is tied so that there is no undue stress on it when the powerhead

moves.

CAUTION: Use cylinder cushions or shock absorbers to decelerate the powerhead return and

prevent excessive (hard stop) vibration, especially in short cycle time applications
operating at high speeds. Repeated shock (over time) could damage a tool.

FIG. 4-9-4a Tool (Nutrunner) Mounting Diagram

Chapter 4: System Setup and Wiring

Page 4-41