Emergi-Lite Total Edge Series - Manual (Page 2)

Universal Recessed and Surface Mount LED EXIT Sign
Tel: (888) 552-6467 Fax: (800) 316-4515 www.tnb.com 11/13 750.1666 Rev. E
2/4
9. Position bar hanger bracket and bar hangers between joists. Make
sure bar hangers are oriented in the correct position. Bar hangers
should be level with bottom of joists or T-bar (see figure 4). Note: when
mounting onto a T-bar the bar hanger will need to be screwed into the
T-bar with 4 self-drilling screw (not supplied) as shown in figure 9.
10. Adjust height of bracket vertically using adjusting slots and tighten all
screws on adjusting slots and bar hanger bracket to secure bar hanger
bracket and bar hanger.
11. Make the proper connections (see figure 5):
a. For 120VAC, connect the black and white wires to the building
utility.
b. For 277VAC, connect the orange and white wires to the building
utility.
c. Connect the green ground wire to the ground.
d. Cap unused wires. In all cases, use suitable wire nuts rated for the
applicable voltage to connect to wires.
Self-powered models:
Be sure to snap the battery connector to the inverter PCB.
12. Connect the test switch connector and insert the LED indicator into the
trim plate, (Self-power models only) then secure the trim plate by using
the provided screws (see figure 6).
13. Insert EXIT panel into main body assembly gently. If EXIT panel is for
a single face, make sure EXIT letter direction is correct (see figure 7).
14. Determine chevron placement: (see figure 8)
a. If a chevron is needed leave the chevron on and remove only the
film instruction.
b. If no chevron is needed remove the chevron and film instructions
together.
15. This unit can be mounted on any flat surface. The Exit panel can be
rotated in any angle from 0° to 180° (see figure 10).
Recessed wall mount
Follow the same directions as in the ceiling mount except when finished
the panel will rotate down 90°.
Recessed Ceiling and Wall Mount Assemble
Tighten screws after positioning
J-box
Bar hanger
Joists
T-bar
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
J-box cover
J-box case
Bar hanger
Main
Trim plate
(2)Screw s
EXIT panel
Chevron
Rotation housing
Front cover
Main frame
Bar hanger
Bracket
end cap
(FM4*15)
T-Bar
4 self-drilling screws
(not supplied)