Emergi-Lite Survive-All SVXH Series - Manual

Emergi-Lite
Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com 12/08 750.1377 Rev. B
1/2
SVXH Series – Class I, Div 2 Combo Unit
SVXH Series – Class I, Div 2 Combo Unit
Installation instructions
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Make sure the area is NON-HAZARDOUS before installing or servic-
ing the unit.
2. Turn off electrical power before and during installation and mainte-
nance.
3. Before opening, turn off electrical power and wait until the unit is cool.
4. Do not install where the marked operating temperatures (T-Code)
exceed the ignition temperature of the hazardous atmosphere.
5. Do not operate in ambient temperatures above those indicated on
the rating labels.
6. Keep tightly closed when in operation.
7. Do not use outdoors.
8. Do not mount near gas or electric heaters.
9. Use caution when handling batteries. Battery acid can cause burns to
the skin and eyes. If acid is spilled on the skin or eyes, flush acid
with fresh water and contact a physician immediatly. Avoid possible
shorting.
10. Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
11. The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
12. Do not use this equipment for other than intended use.
13. Servicing of this equipment should be performed by qualified service
personnel.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off unswitched AC power.
a. Remove the lens-legend (3). Disconnect the lamps from terminal
block (see fig 4) and remove the electronic module (3). Four screws
secure the electronic module to the housing.
b. Determine which holes in the housing will be used for AC wires. Sup-
port frame by two blocks of wood, maximum one inch apart. Strike
knockouts with a hammer and screwdriver. Clear holes of burrs to
allow proper installation of the fitting. Install conduit fitting rated for
Class I Div 2, on the housing. For Nexus option, install the liquid
tight fitting, provided with the unit to route the data cable.
Conduit Entry
a. Install the unit on the wall with 4 screws (not provided). Use the ears
located on each side (see figure 2).
1 3
4 5 6 7 8
9
11
10
2
1
12
13
2
14
Figure 1
Part List
1. Tamper-proof screw
2. Screw covers
3. Lens-legend
4. EXIT panel
5. Diffuser panel
6. Frame
7. Electronic module
8. Electronic module screws
(4)
9. Back plate
10. Swivel
11. MR16 lamp
12. O-ring
13. Lens-emergency light
14. Knock-out covers
15. Junction box
Figure 2
Conduit
Fitting
k’out
ears