Emergi-Lite Weatherproof - EF11D Series - Manual

Emergi-Lite
Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com 10/12 750.1106 Rev. B
Remote heads – Installation instructions
1/1
Emergi-Lite
Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com 10/12 750.1106 Rev. B
1/1
Remote heads – Installation instructions
Installation instructions
Note: Lamp heads may already be attached to the canopy.
1. Determine the final position for the lamp head.
2. Look for the mark on the threaded portion of the swivel to
find the center of rotation for the lamp head.
3. Insert the flat surface from the swivel into the square hole on
the canopy ensuring that the center of rotation is as close as
possible to the final position. Secure the lamp head in place
with the lock washer and nut provided.
4. Adjust the lamp head into its final position.
5. Make the proper connections. The fixture is designed for 6,
12 or 24 VDC (see the lamp voltage indicated on the inside
surface of the canopy). Connect the lamp wires to the DC
supply wires.
6. Use the junction box screws to secure the canopy to the
junction box.
Adjust the lamp head:
Rotation: hold the lamp head and turn it to either side.
-Note: The lamp head can be rotated 150° to either side.
Tilting: hold the lamp head and tilt it up or down.
The lamp head uses a ratchet type mechanism that moves it in
10 degree increments (see fig. 1).
Parts List
1. Lamp head
2. Junction box screws (not provided)
3. Canopy
4. Toothed lock washer
5. Nut
6. Junction box (not provided)
Figure 1
Rotation
Tilt
Center of rotation
Installation instructions
Note: Lamp heads may already be attached to the canopy.
1. Determine the final position for the lamp head.
2. Look for the mark on the threaded portion of the swivel to
find the center of rotation for the lamp head.
3. Insert the flat surface from the swivel into the square hole on
the canopy ensuring that the center of rotation is as close as
possible to the final position. Secure the lamp head in place
with the lock washer and nut provided.
4. Adjust the lamp head into its final position.
5. Make the proper connections. The fixture is designed for 6,
12 or 24 VDC (see the lamp voltage indicated on the inside
surface of the canopy). Connect the lamp wires to the DC
supply wires.
6. Use the junction box screws to secure the canopy to the
junction box.
Adjust the lamp head:
Rotation: hold the lamp head and turn it to either side.
-Note: The lamp head can be rotated 150° to either side.
Tilting: hold the lamp head and tilt it up or down.
The lamp head uses a ratchet type mechanism that moves it in
10 degree increments (see fig. 1).
Parts List
1. Lamp head
2. Junction box screws (not provided)
3. Canopy
4. Lock washer
5. Nut
6. Junction box (not provided)
Figure 1
Rotation
Tilt
Center of rotation