Emergi-Lite Total Edge Series - Manual

Tel: (888) 552-6467 Fax: (800) 316-4515 www.tnb.com 11/13 750.1666 Rev. E
Universal Recessed and Surface Mount LED EXIT Sign
1/4
Universal Recessed and Surface Mount LED EXIT Sign
AC and Self-Powered models
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always
be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. All servicing should be performed by qualified service personnel.
2. Do not use outdoors.
3. Do not let power supply cords touch hot surfaces.
4. Do not mount near gas or electric heaters.
5. Equipment should be mounted in locations and at heights where it will
not readily be subjected to tampering by unauthorized personnel.
6. The use of accessory equipment not recommended by the manufacturer
may cause an unsafe condition.
7. Do not use this equipment for other than intended use.
8. Use caution when handling batteries. Battery acid can cause burns to the
skin and eyes. If acid is spilled on the skin or eyes, flush acid with fresh
water and contact a physician immediately. Avoid possible shorting.
9. Allow battery to charge for 24 hours before first use.
SAVE THESE INSTRUCTIONS
Importunities sign shall be installed only where there is adequate colour
contrast between the sign legend and the interior wall finish behind the
sign, to provide for sufficient visibility.
Installation Instructions
Turn off AC power.
Recessed Ceiling Mounting
1. Refer to assembly drawing before you start installation (see figure 9).
2. Remove the front cover from the main frame by gently prying it open with
a screwdriver then connect the battery connectors together.
3. Feed AC supply wires out of the main frame, then reinstall the front
cover.
4. Remove 1 screw (PB3*12) from the top of the left and right end caps (see
figure 2).
5. Mount the left bar hanger bracket onto the left end cap and screw it in
with screws (PB3*15 and TM4*8), (do not pass the wires through this
bracket) (see figure 3a).
6. Mount the right bar hanger bracket onto the right end cap and screw it in
with screw (PB3*15 and plastic rivet), (pass the wires through this
bracket) (see figure 3a).
7. Remove j-box cover and mount j-box case onto the main frame using the
2 screws (TM4*8). Feed AC supply wires into the j-box.
8. Mount bar hangers onto the bar hanger brackets with 4 screws (TM4*8)
(see figure 3a or 3b depending on bar hanger configuration).
WARNING:
Risk of Shock.
Disconnect Power before Installation.
Figure 1
Package Contents
1. LED Edge-Lit EXIT Sign.
2. Adjustable Bracket and Bar
hanger.
3. Hardware Bag.
4. Canopy
5. Mirror Film (Converts
double face to single face.)
Hardware Bag
(1)
(2)
(11)
(2)
(3)
Figure 2
Front cover
(2)Screws (PB3*12)
Right end cap
Left end cap
J-box cover
J-box
Bar hangers
(2) Screws
(2) Screws
Plastic
Bar
(PB3*15)
(TM4*8)
hanger Bracket
rivet
Figure 3a
!"
(5) Screws (FM4*8)
J-box cover
Bar hanger
Bar hanger bracket
Left connect bracket
Right connect bracket Figure 3b