Emergi-Lite EFR2 Distinction Series - Manual

Emergi-Lite
Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com 05/08 750.0943 Rev. B
Distinction Series - Self-Powered Pot-Lite
1/2
Distinction Series - Self-Powered Pot-Lite
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. Do not mount near gas or electric heaters.
4. Use caution when handling batteries. Avoid possible shorting.
5. Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
6. The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
7. Caution: If optional Halogen cycle lamp(s), symbol (H—), are used in
this equipment, to avoid shattering: do not operate lamp in excess of
rated voltage, protect lamp against abrasion and scratches and
against liquids when lamp is operating, dispose of lamp with care.
8. Halogen cycle lamps operate at high temperatures. Do not store or
place flammable materials near lamp.
9. Do not use this equipment for other than intended use.
10. All servicing should be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
2. Carefully unpack the emergency lighting unit. Set the light unit aside
when installing the back box.
3. Remove the junction box cover by releasing the spring. Break the
appropriate knockout for AC supply on the back box (see fig. 2).
Choose the proper mounting solution: new sheet rock construction or
suspended ceiling. Follow the proper mounting section and continue the
installation at step 4.
New sheet rock construction
a. Slide the hanger bars through the tabs on the back box. For each
side, first slide the bar that has two small arrows at its end facing
outside the box. Then slide the one with a long slot on top of the
first one. The two arrows should go through the long slot on the
second bar. Place the assembly between the framing members.
Align the open round surface of the box where the finished sur-
face of sheet rock will be and nail bars to the framing members
(see fig. 3).
1
2
5
6
4
3
7
Figure 1
Part List
1. Back box
2. Hanger bars
3. Hanger bar nail
4. Junction box cover
5. Light unit
6. Self-drilling screw (3)
7. Suspended ceiling clip (4)
Knockout holes
Figure 2
Pull out to open
box cover
the junction
Figure 3
Tabs
First hanger bar
to slide
Second hanger
bar to slide
Small arrows
go through the
slot on the
second bar