Fulton Classic ICX or FB-F Vertical Tubeless Boilers (Steam) Oil Fired - Manual (Page 5)

Introduction
This manual is provided as a guide
to the correct operation and mainte-
nance of your Fulton Oil Fired
Steam Boiler, and should be perma-
nently available to the staff respon-
sible for the operation of the boiler.
These instructions must not be con-
sidered as a complete code of prac-
tice, nor should they replace exist-
ing codes or standards which may
be applicable.
The requirements and instructions
contained in this section generally
relate to the standard Fulton Oil
Fired Steam Boiler. When installing
a packaged unit, this entire section
should be read to ensure that the
installation work is carried out cor-
rectly.
Prior to shipment the following tests
are made to assure the customer
the highest standards of manufac-
turing:
a) Material inspections.
b) Manufacturing process
inspections.
c) ASME welding inspections.
d) ASME hydrostatic test
inspection.
e) Electrical components
inspection.
f) Operating test.
g) Final Engineering Inspection
h)
Crating inspection.
NOTE
The installation of the Fulton oil
fired Steam Boiler should be car-
ried out by competent personnel
in accordance with the standards
of the National Fire Protection
Association, National or
Canadian Electrical Code. All
state and jurisdictional codes
beyond the scope of the applica-
ble ASME boiler and pressure
vessel codes, for its correspond-
ing classification, should be fol-
lowed in all cases. Jurisdictional
authorities must be consulted
prior to installation.
All units are crated for fork lift trans-
port. Once uncrated, all units can be
transported with a forklift. Under no
circumstances should weight be
allowed to bear on the jacket, con-
trol panel, or fan housing of any
Fulton Boiler.
The customer should examine the
boiler for any damage, especially
the refractories.
Rigging your boiler into
position should be handled by a
competent rigger experienced in
handling heavy equipment.