Fulton Vertical Tubeless (FT-A) Thermal Fluid (hot oil) Heater - Manual (Page 10)

© The Fulton Companies 2013
INSTALLATION
FTA-IOM-2013-0227
SECTION 2
2-4
FIGURE 1 -COMPONENT VIEW OF THE FT-A THERMAL FLUID HEATER
A
B
C
D
Legend
A Top Mounted Burner
B Electrical Control Panel
C Convection Fins
D High Density, High Temperature
Insulation
Notes
The top-mounted down fi red burner
delivers a spinning fl ame down the
length of the furnace. As the fl ame swirls
downward in a controlled fl ow pattern,
the fl uid spirals upward in the pressure
vessel. Hot gases from the fl ame are
carried up the outside of the vessel in
the secondary fl ue passage convection
area. Convection fi ns welded along the
full length of the vessel transmit the
remaining heat through the outer side
of the fl uid vessel and into the fl uid. The
result is even heating of thermal fl uids
for optimal thermal effi
ciency.
FIGURE 2 - DIMENSIONS (REFER TO TABLE 2)
D