Asus AP1720-E2 - Manual (Page 96)

Chapter 4: Motherboard info 4-8
1. Floppy disk drive connector (34-1 pin FLOPPY1)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive.
4.3 Connectors
2. Serial ATA connectors (7-pin SATA1, SATA2)
These next generation connectors support the thin Serial ATA cables
for Serial ATA hard disks. The current Serial ATA interface allows up to
150 MB/s data transfer rate, faster than the standard parallel ATA with
133 MB/s (Ultra ATA/133).
If you installed Serial ATA hard disks, you may create a RAID 0/RAID 1
configuration using the RAID feature of the Intel
® 6300ESB ICH. Refer
to page 5-26 to 5-27 for the SATA configuration.
NCCH-DL
®
NCCH-DL SATA connectors
SATA2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXN2
RSATA_RXP2
GND
SATA1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
NCCH-DL
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
NCCH-DL Floppy disk drive connector
PIN 1
FLOPPY 1