Asus AP1720-E2 - Manual (Page 70)

Chapter 2: Hardware setup 2-50
2.10.6 Chassis footpads and roller wheels
The barebone server system is shipped with four footpads attached to the
bottom of the chassis for stability. You need to remove these footpads if:
• if you want to replace the footpads with the bundled roller wheels
• you wish to install the system to a rack
(Refer to “Chapter 3 Installation options” of this user guide, and to the
“Rackmount Kit” user guide for instructions)
To remove the footpads:
1. Lay the system chassis on its
side.
2. Use a flat screwdriver to flip out
the top layer of a footpad.
4. Repeat steps 2 and 3 to remove the other three footpads.
3. Remove the footpad by rotating it
counterclockwise.