Asus AP1720-E2 - Manual (Page 120)

Chapter 5: BIOS setup 5-16
Extended IDE Drive [Auto]
When set to [Auto], allows automatic selection of the extended IDE drive
installed, if any. Set this item to [None] if there is no extended IDE drive, or
if you do not wish to detect the drive even if installed. Configuration
options: [None] [Auto]
Access Mode [Auto]
Configuration options: [Large] [Auto]
5.3.6 Fourth IDE Master
When configuring a drive as Fourth IDE Master, refer to section “4.3.1
Primary IDE Master” and section “5.3.5 Third IDE Master” for the menu
item descriptions.
5.3.5 Third IDE Master
When configuring a drive as Third IDE Master, refer to section “4.3.1
Primary IDE Master” for the menu item descriptions which are not
discussed in this section.
The items Third IDE Master and Fourth IDE Master appear only if
you set the On-Chip Serial ATA item in SATA Configuration menu to
either [Auto] or [Enhanced Mode]. See page 5-26 for information.
Third IDE Master
Extended IDE Drive [Auto]
Access Mode [Auto]
Capacity 0 MB
Cylinder 0
Head 0
Precomp 0
Landing Zone 0
Sector 0
Transfer Mode None
S.M.A.R.T Status None
Item Specific Help
Selects the type of
fixed disk connected
to the system.
Select Menu