PASCO CI-6538 Rotary Motion Sensor - Manual (Page 10)

®
Model No. CI-6538 Rotary Motion Sensor
9
b) Mounting the RMS to a Dynamics Track
The Rotary Motion Sensor can be mounted to a Dynamics Track using
the IDS Mount Accessory. To mount the RMS to the track, do the
following: a) Slide the square nut into the insert on the side of the
track. b) Slide the horizontal rod from the IDS mount through the hole
on the clamp of the RMS. Tighten the screw on the RMS clamp to
hold the rod in place. c) Tighten the screw on the IDS mount to the
square nut in the track. (See Figures 5a and 5b.)
thin rod
space
RMS
3-step Pulley
support rod
Figure 4: Mounting the Rotary Motion Sensor with the
thin rod from the mini-Rotational Accessory
Figure 5a: Attaching the IDS bracket to the track
IDS mount
track