Nova-Tech PGW Series - Manual (Page 8)

Page 8 of 44
5.0 SETTING UP THE BALANCE
5.1 ASSEMBLING THE BALANCE
• Locate the balance on a solid surface, free from vibration
• Gently place the 4 pan supports (if not already fitted) and then the
stainless steel pan on the weighing platform
• Place the draught shield frame and the top cover around the pan (for
mg models only)
• Level the balance using the adjustable feet and spirit level
• Connect power to the balance
• For best performance, let the balance warm up for 30-60 minutes and
calibrate before using
5.2 LEVELLING THE BALANCE
After placing the balance in a suitable place,
level it by using the spirit level on the rear of the
balance. To level the balance turn the two
adjustable feet at the rear of the balance until
the bubble in the spirit level is centred.
5.3 WARM-UP TIME
Attach the power supply cable to the connector
on the rear of the balance. Plug the power
supply module into the mains. The display will
indicate the balance serial number (if set) and
the software revision number followed by the
capacity of the balance. Next the balance will
run a self-test by displaying all segments
followed by a symbol indicating the balance is in
busy mode. If the balance serial number is not
set the display will show dashes. The display
will show zeroes accompanied by the
О0Н
symbol. If the balance is not used for a long
time, it will go back to the auto-calibration mode.
© Adam Equipment Company 2007