Nova-Tech PGW Series User Manual

Page 27

Page 27 of 44

Tare weight

Tare: xxx.xxx g

Unit weight

Unit wt: xxx.xxx g

Count

Count: xxxx pcs

Reference weight

Ref. wt: xxx.xxx g

Percent

Percent: xx.xxx %

Checkweigh lower limit

Low: xxx.xxx g

Checkweigh upper limit

High: xxx.xxx g

A blank line printed

only.

Any of these can be printed on any of the 15 lines available. Not all items
need to be used and any one can be used more than once (see section 13.3).

The data for each form will be preceded by a start-of-header
character (01) and terminated with an end-of-transmission character
(04). These characters will be ignored by a serial printer but will allow a
computer program which reads the data to distinguish between this block
report format and the single-line output format described above.

STANDARD FORMAT

The balance will print the following data as the standard form. The standard
form cannot be changed. The format of the custom forms #1 and #2 will be
the same as the standard form until modified by the user.

Line 1

Date

Line 2

Time

Line 3

Blank line

Line 4

ID number

Line 5

Blank line

Line 6

Result

Line 7

Blank line

Line 8

Blank line

This will result in a printout that looks like:

Date: 23/09/04
Time: 15:45

ID No: 123456

Net: 123.456 g

*NOTE: The format of the results line will change depending on the mode in

which the balance is operating, e.g.

Normal weighing, Check weighing, Animal weighing: “123.456 g”

Parts counting: “1234 pcs”

Percent weighing: “12.345 %”