Nova-Tech PMB Moisture Analyzer - Manual (Page 39)

37
| P a g e © Adam Equipment Company 2009
8.0 PRINT AND STORE RESULTS
If the test parameters are set to allow the test results to be printed (see
section 6.1.1) then the results of the test are printed both before and after
the test is complete. The initial part of the printout will show the test
conditions, If the test printing parameter has been set to complete then the
results will be printed at the interval time. When a test is completed, the user
can print a result from the test. At the same time as the printing is happening
the results are stored in the analyzer memory. The results can be recalled
from the analyzer memory for printing over the serial interface.
8.1 PRINTING FINAL TEST RESULTS
While the final values for the test are being displayed after the test has
ended, press the [Print] key to output the final results. The format of these
results are the same as the last lines of the complete printout:
LAST TEMP: 111C
TEST TIME: 05:30 Min
FINAL MASS: 11.820 g
MASS LOSS: 0.521 g
RESULT: 4.27 %M
8.2 STORING TEST RESULTS
If the test settings include the printing of results being enabled the analyzer
will store the results of the test into memory. (See section 6.1.1) The test
results will be stored using the file name given to it automatically by the
analyzer. In the form RESxxxxx
The analyzer is capable of holding up to 99 test results. If the analyzer
memory is full the display will show an MEM FULL message. Delete some of
the stored results to make room for new test results. See section 8.4.