Diamond Products CC6566 - Manual (Page 15)

CC6566 - CC6566-3 Concrete Saw Manual
Adjusting the Rear Pointers
Figure 7: Rear Pointer Rod
1. Loosen the screw on the back of the frame
edge to adjust the rear pointer rod’s length and
to move the pointer up or down, and then
retighten the screw to secure.
Battery
WARNING
 Ignitable explosive gases are
emitted from the battery. DO
NOT expose the battery to
sparks or open flames, and keep the area
around the battery well-ventilated.
CAUTION
 Use a proper battery tester, such as a
voltmeter, to test the battery
strength.

Use protective eyewear or a face
shield, and avoid contact with the
skin when handling a battery.
The saw contains a charged battery with one
positive battery cable lead and one negative battery
cable lead.
Diamond Blades
WARNING
 DO NOT exceed the blade’s
maximum recommended speed
when cutting. Excessive blade
speeds can cause blade breakage, resulting in
serious injuries and/or death.
Using the proper blade (size and type) preserves
the blade and improves cutting and operator
efficiency, resulting in lower costs. Refer to
www.diamondproducts.com for a list of different
blade types and additional blade information.
Inspecting the Blade
Inspect each blade prior to installation and discard
all damaged blades. Inspect all blades for:
 Cracks, nicks, and dents.
 A damaged and/or deformed arbor (center
hole).
 Darkness and/or discoloration near edge of
blade.
 A deformed blade circumference.
 Segment loss and/or segment cracks.
 Core
wear.
 Bending.
 Uneven
side-widths.
15