Diamond Products CC6566 - Manual (Page 11)

CC6566 - CC6566-3 Concrete Saw Manual
Controls
Figure 2: Saw Controls
1. Ignition Switch–Starts engine.
2. Coolant Temperature Gauge–Gauge
pointer indicates engine temperature.
Pointer should remain below red indicator to
avoid overheating.
3. Parking Break Lever.
4. Water Valve–Controls water flow to blade.
5. Handle Lock Knobs–Secure handlebars to
frame upright.
6. Engine 4 Warning Light Gauge–Oil
pressure, alternator, water temperature and
glow plugs.
7. Fuel Filler / Gauge Cap–Opening to add
fuel; indicates fuel level.
8. Engine Throttle Control–Increases and
decreases engine speed/blade speed
(RPM).
9. Blade Tachometer/Hour Meter–Indicates
blade RPM; total number of saw hours
operated
10. Transmission Engagement Lever–
Engages/disengages transmission.
11. Raise Pushbutton–Raises saw and blade.
12. Travel Speed Control Lever–Controls
forward/neutral/reverse motion of saw.
13. Lower Pushbutton–Lowers saw and blade.
14. Lowering Speed Valve (Optional Item) –
Changes saw’s lowering speed.
15. Emergency Stop Button–Stops engine.
16. Spotlight Switch (Optional Item)–Powers
spotlight.
17. Water Pump Switch (Optional Item)–
Pumps water to blade.
18. Water Safety Switch (Optional Item)–
Detects an improper water pressure.
19. Pointer Rope Cleat–Secures front pointer
cable.
20. Cutting Depth Indicator–Indicates blade’s
depth from surface.
21. Depth Stop Knob–Secures cutting depth.
22. Air Cleaner Restriction Indicator–
Determines when to service air cleaner
11