MIDLAND Geopoint Box SMS - Manual (Page 43)

42
Reading and Writing SMS Commands
Writing Commands
Command Meaning and Values Example
wposc Set the cyclic position SMS in text format and the
relevant power save mode.
[enabling: 0=disable, 1=enable]
[rate: 01÷99 minutes]
[power save mode: 0=disable, 1=enable]
NOTE: the power save mode works only with
SMS rate
5 minutes.
Never set like this: wposc=0,xx,1
NOTE: to enable or disable only the cyclic position
SMS, send the wposc command with the fi
rst
fi eld only. In this case, the previously set rate is
considered.
Case A
Command:
wposc=1,01,0
Reply: wposc=1,01,0 OK
Description:
1=enables the cyclic position SMS
01=1 minute rate
0=disables the power save mode
Case B
Command:
wposc=1
Reply: wposc=1 OK
Description:
1=enables the cyclic position SMS with
the previous set rate
wms Set the accelerometer values.
[sensitivity: 00=disables sensor, 01=maximum,
10=minimum]
[timeout: 01÷99 minutes] Command: wms=02,10
Reply: wms=02,10 OK
Description:
02=sensitivity level 2
10=10 minutes timeout
wem Erase all position data recorded in the memory. Command: wem
Reply: wem OK