MIDLAND Geopoint Box SMS - Manual (Page 42)

41
Reading and Writing SMS Commands
Command Meaning and Values Example
rposc Read cyclic position SMS setup and power save
mode status.
[status: 0=disabled, 1=enabled]
[rate: 01÷99 minutes]
[power save mode: 0=disabled, 1=enabled] Command: rposc
Reply: rposc=1,01,0
Description:
1=enabled cyclic position SMS
01=1 minute rate
0=disabled power save mode
rms Read the accelerometer setup values.
[sensitivity: 00=disabled sensor, 01=maximum,
10=minimum]
[timeout: 01÷99 minutes] Command: rms
Reply: rms=02,10
Description:
02=sensitivity level 2
10=10 minutes timeout
rgf Read the Geofence setup.
[status: 0=disabled, 1=enabled]
[LAT1,LONG1,LAT2,LONG2=latitude and
longitude of the 2 points which defi ne the Geofence
area] Command: rgf
Reply:
rgf=1,45g37.7981N,008g28.8012E,
41g37.8971N,012g28.8012E
Description:
1=enabled
45g37.7981N,008g28.8012E=latitude
and longitude of the fi rst point
41g37.8971N,012g28.8012E=latitude
and longitude of the second point
ranc Read the Anchor setup.
[status: 0=disabled, 1=enabled]
[radius: 0050, 0100, 0200, 0300, 0500, 0700, 1000,
1500, 2000, 3000, 4000 m] Command: ranc
Reply: ranc=1,0100
Description:
1=enabled
0100=radius at 100 m