MIDLAND Geopoint Box SMS - Manual (Page 30)

29
Use of the Functions
Programming
To use this function, it is necessary to send to the tracker an SMS command by a mobile phone or by a GSM
device and waiting for the reply.
1) Tracker position request in realtime Sending an SMS command (rpos)
Automatic Position Sending
The tracker can send its own position at a programmable rate. The automatic position sending can be carried
out in two different modes:
by SMS •
by GPRS connection •
CYCLIC POSITION SMS
The tracker can send an SMS message at intervals, containing all the information on its current position. This
function is useful for monitoring the tracker motion at a distance by a mobile phone.
Programming
To use this function, it is necessary to set the phone number where the position messages will be sent, set
the rate for cyclic position SMS and then enable the function.
1) Set the phone number Using the provided software
2) Set the rate for cyclic position SMS Sending an SMS command (wposc)
Using the provided software
3) Enable the cyclic position SMS Sending an SMS command (wposc)
Using the provided software