MIDLAND Geopoint Box SMS - Manual (Page 36)

35
Use of the Functions
Power Save Mode
The Power Save Mode allows for optimal management of the tracker battery. It is possible to set the tracker
automatic switching on/off according to specifi c use requirements.
NOTE: It is not possible to enable more than one Power save mode simultaneously.
NOTE: When the tracker is switched off in Power save mode, an SOS message can be sent
pressing the relevant red key for at least 2 seconds.
The fi rst mode allows the automatic tracker switching on at motion detection. When no motion is detected for
a preset time and there is no data exchange, the tracker will automatically switch off.
The second mode allows the automatic tracker switching on at the cyclic position SMS sending. Before using
this mode, enable and set the Cyclic position SMS function with SMS rate
5 minutes. The tracker will switch
off automatically after position SMS sending and after carrying out all the preset operations.
During the automatic switching on, if the tracker is connected by the provided software, the automatic
switching off will be carried out after position SMS sending, after carrying out all the preset operations and 2
minutes after tracker disconnection.
The third mode allows the automatic tracker switching on at the cyclic GPRS connection with the provided
software or with the I-Scout web server. Before using this mode, enable and set the Cyclic GPRS connection
function with rate
5 minutes. The tracker will switch off automatically after carrying out all the preset
operations. If the GPRS connection fails twice, the tracker will switch off automatically.