Meriam M4 Series Precision Calibrator Data Logger Manual - Manual (Page 4)

ZM4 Instruction Manual 9R87-B June 2012
4
Certification/Safety/Warnings
Fire/Explosion Hazard. This instrument is not intrinsically
safe. DO NOT use in areas that may contain flammable
gas or vapors, combustible dusts or ignitable fibers where an unintended
spark can cause a fire/explosion.
Do not exceed the Pressure Limits listed in the
Specifications section of this manual. Failure to operate
within the specified pressure limit could result in minor or moderate injury
Substitution of components may impair operation and safety.
Disconnect power before servicing.
The product should not be powered with a combination of new and old
batteries.
The product should not be powered with a combination of batteries from
different manufacturers.
User must use a wrench on the pressure manifold
when installing user’s 1/8” NPT fitting. Do not tighten
the fitting without using a wrench on the pressure manifold. Failure to use a
wrench on the manifold will damage the plastic enclosure and void warranty
No torque should be applied to the manifold with respect to plastic enclosure.
Safety Information
Failure to follow all instructions could result in injury. Read,
understand and follow all safety warnings and instructions provided
with this product. Also, meet or exceed your employer’s safety
practices.
In no event shall Meriam be liable for any indirect, special, incidental,
consequential or punitive damages or for any lost profits arising out of or
relating to any services provided by Meriam or its affiliates. It is not possible
for Meriam to identify all foreseeable uses/misuses, therefore all persons
involved in commissioning, using or maintaining this product must satisfy
themselves that each intended application is acceptable.