Meriam M4 Series Precision Calibrator Data Logger Manual User Manual
Page 30
ZM4 Instruction Manual 9R87-B
June 2012
30
Installing Wire Stand
All M4 units come standard with an installed rear hand strap and a separate
wire stand. To install the wire stand first pull down on the loose end of the
Velcro strap to separate it, then carefully pull the strap through the lower
bracket. Next remove the two Phillips screws that secure the top metal
bracket.
Locate the plastic bag that contains the wire stand, rubber mounting bracket,
and two Phillips screws. Align the plastic mounting holes with the two brass
inserts. Please make sure the straight edge is facing upward toward the
pressure manifold as shown in the illustration. Secure the plastic mounting
block to the enclosure by tightening the screws.
Figure 24: Installing Wire Stand