Meriam M2110P SMART PRESSURE GAUGE - Manual (Page 32)

32
23. Service and Calibration
In the event an M2110 requires service or needs to be returned for factory recertification,
battery replacement, or re-calibration, please contact Meriam at the numbers listed below.
The battery board should only be replaced by properly trained technicians in a controlled
environment. Contact Meriam for further details.
DO NOT send any unit in for service without first contacting Meriam for a Return
Material Authorization (RMA) number. If this number has not been obtained and
clearly marked on the return packaging, the unit will be returned at the shipper’s
expense. An RMA number will be provided by the Meriam Repair Department when you
call, fax or e-mail your information. Certification for Non-Hazardous Materials will also be
required. The RMA number must accompany all incoming packages to insure proper
tracking, processing and repair work.
To assist us in processing your service request, please have the Model & Serial Number of
the unit available when you call. This information is located on the product label.
Meriam Process Technologies
10920 Madison Avenue
Cleveland, Ohio 44102
TELEPHONE: (216) 281-1100
FAX: (216) 281-0228
E-mail: [email protected]
Web Site: www.meriam.com