Meriam M2110P SMART PRESSURE GAUGE - Manual (Page 29)

29
User’s Manual Dwg No 9R141-IR
19. Outline Dimensions
20. Panel Mounting
20. Panel Mounting
1. Make a ¼ DIN panel cutout per drawing.
2. Remove the two 6-32 socket head screws in
the grooves at the rear of the gauge.
3. Slide the panel mount jacks out of the
groove.
4. Insert the gauge through the front of the
panel.
5. From the rear, insert the panel mount jacks in
the grooves on the side of the gauge, and
slide them firmly against the panel.
6. Replace the two 6-32 socket head screws in
the grooves behind the panel mount jacks.
7. Tighten the panel mount jack against the
panel with the two socket head screws.
8. Refer to the note on page 28 when making
pressure connections.
3.60" +/- 0.010
(92)
( ) DIMENSIONS IN MILLIMETERS
3.60" +/- 0.010
(92)
PANEL MOUNTING CUTOUT DIMENSIONS