Meriam M2110P SMART PRESSURE GAUGE - Manual (Page 2)

2
Safety Information
Failure to follow all instructions could result in injury. Read, understand and follow all safety
warnings and instructions provided with this product. Also, meet or exceed your employer’s
safety practices.
In no event shall Meriam be liable for any indirect, special, incidental, consequential or punitive
damages or for any lost profits arising out of or relating to any services provided by Meriam or its
affiliates. It is not possible for Meriam to identify all foreseeable uses/misuses, therefore all persons
involved in commissioning, using or maintaining this product must satisfy themselves that each
intended application is acceptable.
Safety Warnings
The table below defines the safety symbols, signal words and corresponding safety messages used in
the manual to identify potential hazards and are intended to warn persons about hazards that could
result in personal injury or equipment damage.
This is the Read Instruction Manual symbol. This symbol indicates
h that you must read the instruction manual.
This is the Safety Alert symbol. This symbol indicates a WARNING.
Warnings alert you to actions that can cause personal injury or pose
a physical threat. Please read these carefully.
This is the Safety Glasses symbol. This symbol indicates that you
must wear approved safety glasses during the task.
This is the Safety Gloves symbol. This symbol indicates that you
must wear approved safety gloves during the task.
Indicates a potentially hazardous situation which, if not
avoided, will result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, could result in minor or moderate injury.
Indicates information essential for proper product
installation, operation or maintenance.
Information in this document is subject to change without notice. Check the Meriam web site
(
www.meriam.com ) for the latest manual revision.
For customer assistance please call your local Meriam representative or Meriam directly.
Meriam Process Technologies
10920 Madison Avenue
Cleveland, Ohio 44102
Telephone: (216) 281-1100
Fax: (216) 281-0228
E-mail: [email protected]
Web: www.meriam.com