Luminex MAGPIX User Quick Guide - Manual (Page 6)

Detailed instructions on how to install the MAGPIX System are provided in the PC Installation
Instructions (89-30000-00-263) and Installing MAGPIX (89-30000-00-236) foldouts that you
received with the instrument.
This manual provides step-by-step instructions on how to start your MAGPIX system for the
first time, how to perform daily operations, and how to properly maintain the instrument.
WARNING: Improper installation or use of the MAGPIX System can result in
injury, damage to the instrument, and/or incorrect results.
Before installing or using MAGPIX you must complete the
training modules located in the Training tab at http://
www.luminexcorp.com/MAGPIX
Additional "How-To" videos describing specific operations can
be found on the same page under the Support tab.
Starting xPONENT
Perform the following steps to launch xPONENT:
• On the PC desktop, click the Luminex xPONENT icon, or click Start > All Programs >
Luminex > xPONENT > Luminex xPONENT.
• If you have a trial license, contact Luminex Technical Support to obtain a full license, or
click OK in the dialog box to continue.
• If this is the first time you have started the software, the User License Agreement may
display. Read the license agreement. Select I accept the terms of this license
agreement, then click OK.
NOTE: For safety and legal information, refer to the MAGPIX Installation and
Hardware User Manual that you received with your instrument.
Start-up Indicators
When you turn on the Luminex MAGPIX system, the following start up indicators occur:
Chapter 1: Starting the MAGPIX System
for the First Time
1