Magnum Venus Plastech HIS SUPERCHARGED - Manual (Page 6)

SUPERCHARGED H.I.S.™
6. Slide catalyst pump toward the connecting arm and re-insert quick pin into
slave arm hole just in front of catalyst pump bearing block.
7. Attach air source to manifold fitting.
8. Remove the lid from the flush tank and fill with clean suitable solvent.
Replace the lid. (See Fig. 2E)
9. Slowly bring flush regulator up to 85 psi (turn clockwise).
Fig. 2C Fig. 2D
Fig. 2E
2
1/2” diameter (minimum) air hose with a recommended
100 psi of clean, dry air should be used for maximum
efficiency.
NOTE
Flush tank pressure should never be higher than 85 psi.
CAUTION
This will allow resin pump to stroke, but prevent catalyst
pump from moving during start-up. Never have the
catalyst pump connected except when actually spraying
a laminate or damage to the catalyst system may occur.
NOTE