Magnum Venus Plastech HIS SUPERCHARGED User Manual

Page 16

SUPERCHARGED H.I.S.™

Removing Materials

From The System

You may find a need to remove materials from the system periodically if you plan

a long term shut-down, are changing resin types or are making other material
switches.

1. Remove resin wand from material and allow to drain.

2. Place wand in approximately 2 gallons of solvent and clean wand.

3. Aim gun into suitable container and carefully open gun by pulling trigger.
Lock trigger open.

4. Open resin pump air valve and turn resin pump regulator up until pump
begins tostroke even, slow strokes. Continue to cycle solvent through resin
system until solvent appears clean. Note: Additional solvent may be required
depending onhow clean the unit needs to be.

5. Shut off resin regulator, and close resin pump air valve.

6. Remove the charge from the resin accumulator by inserting a 1/8” diameter
rod(provided) into fitting at the top the resin accumulator. Keep rod pushed
against the check valve until all air is exhausted. (See Fig. 6A & 6B)

NOTE

These steps may be followed when performing maintenance, or
for shutting the system down for long periods of time. Follow
steps 1 through 10 of the shut-down procedure before the
beginning of material removal.

Chapter