Magnum Venus Plastech HIS SUPERCHARGED - Manual (Page 14)

SUPERCHARGED H.I.S.™
Shut-Down Procedure
1. Turn the resin pump air valve to the off position. Leave gun air supply at 90 to
100 psi.
2. Pull the top quick pin from the catalyst pump slave arm. Slide catalyst pump
toward the connecting arm and re-insert quick pin into slave arm hole just in front
of catalyst pump bearing block. (See Fig. 5A)
3. Remove nozzle assembly and turbulent mixer from gun. Clean these parts
and set aside. Check for wear.
4. Hold gun over suitable container and pull trigger allowing resin and catalyst
fluid pressure to drain completely.
10
This will allow resin pump to stroke, but prevent catalyst pump
from moving during Shut-down procedure. It should be
general procedure to never have the catalyst pump connected
except when actually spraying a laminate.
CAUTION
Fig. 5A
Chapter
5 55
55