Magnum Venus Plastech INNOVATOR II CONTROL UNIT - Manual (Page 14)

INSTALATION/OPERATIONS MANUAL
INNOVATOR II
MAGNUM VENUS PLASTECH REV 1.40
MAY 2012 PAGE 14
CHAPTER 4-Overview of Controls
Overview of controls
The Innovator control panel is shown in figure 4.10. Controls have been grouped based upon function, to make the
system as user friendly as possible.
A brief overview of controls is as follows:
Emergency Stop

Push button Press this button in the event of an emergency to place the system in a
safe state. Twist and pull to release and allow machine operation.
Pump pressure

Pressure gauge This is the air pressure being supplied to the pump.

Regulator Adjust this to control the air pressure being supplied to the pump and set
the pump speed.
Flush/Alarms

CAT/OP Indicator will turn red if overpressure state exists.

RGA ALARM Indicator will turn red if gel alarm timer has expired.

Pushbutton Press this button to operate the flush cycle.
Mold Pressure Guard

Preset level gauge Control signal air pressure being supplied to Mold Pressure Guard
(MPG) control.

Regulator Use this to adjust the MPG control signal air pressure.
Start/Stop Controls

Inject Press to start the machine in inject mode.

Recirculate Press to start the machine in recirculation mode.

Stop Press to stop the machine in injection, recirculation or flush modes.
Stroke Counter
Set a predetermined stroke count for the machine to stop at.