Liquid Controls POD - Manual (Page 3)

safety Procedures
! WarnInG
North America - Installations must be in full accordance with the National Electrical Code (US) or the Canadian
Electrical Code respectively to maintain the hazardous location ratings on the product.
Outside of North America - Installations must be in full accordance with EN 60079-14 to maintain the hazardous
location ratings on the product. Use Ex d certified cable glands only. For ambient temperatures above 70ºC, use field
wiring rated 20ºC above the maximum ambient temperature.
WARNING: Explosion Hazard -
Substitution of components may impair suitability for hazardous area applications.
WARNING: Explosion Hazard -
When in hazardous locations, turn power OFF before replacing or wiring modules.
WARNING: Explosion Hazard -
Do NOT disconnect equipment unless power has been switched OFF or the area is known to be Non-Hazardous.
observe national and
local codes
! WarnInG
be Prepared
• Before using this product, read and understand the instructions.
• All work must be performed by qualified personnel trained in the proper application, installation, and
maintenance of equipment and/or systems in accordance with all applicable codes and ordinances.
• When handling electronic components and boards, always use proper Electrostatic Discharge (ESD)
equipment and follow the proper procedures
• Make sure that all necessary safety precautions have been taken.
• Provide for proper ventilation, temperature control, fire prevention, evacuation, and fire management.
• Provide easy access to the appropriate fire extinguishers for your product.
• Consult with your local fire department, state, and local codes to ensure adequate preparation.
• Read this manual as well as all the literature provided in your owner’s packet.
• Save these instructions for future reference.
• Failure to follow the instructions set forth in this publication could result in property damage, personal injury,
or death from fire and/or explosion, or other hazards that may be associated with this type of equipment.
Before disassembly of any meter or accessory component:
• All internal pressures must be relieved and all liquid drained from the system in
accordance with all applicable procedures.
• Pressure must be 0 (zero) psi.
• Close all liquid and vapor lines between the meter and liquid source.
Failure to follow this warning could result in property damage, personal injury, or death from
fire and/or explosion, or other hazards that may be associated with this type of equipment.
! WarnInG
be Prepared Safely Evacuate
Piping System
3