beautypg.com

Installation – connecting the wires – Controlled Products Systems Group E-9643-4B190Q User Manual

Page 9

background image

ENFORCER Long-Range Barrier Sensors

SECO-LARM U.S.A., Inc.

9

Installation – Connecting the Wires

1. Unscrew and pull the end cap off the side of the receiver with the terminal block

(see Fig. 11).

2. Run the wires through the rubber wire hole in the top corner of the back of the end cap.

3. Program the receiver (see pg. 11).

4. Replace the end cap. NOTE: End cap must be off when aligning the sensor.

5. Use a screwdriver to tighten the screws holding the end cap in place.

Receiver

1. Unscrew and pull the end cap off the side of the transmitter with the terminal block

(see Fig. 12).

2. Run the wires through the rubber wire hole in the top corner of the back of the end cap.

3. Program the transmitter.

4. Replace the end cap. NOTE: End cap must be off when aligning the sensor.

5. Use a screwdriver to tighten the screws holding the end cap in place.

Transmitter

Fig. 11 – Receiver circuit board

Fig. 12 – Transmitter circuit board

This manual is related to the following products: