Controlled Products Systems Group E-9643-4B190Q - Manual (Page 12)

ENFORCER Long-Range Barrier Sensors
12 SECO-LARM U.S.A., Inc.
MiE-96xx-xB190QXX_1107.docx
PITSW3
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for a
period of one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or replacement of
any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or
alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is
not operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or
property damages of any kind to the purchaser or anyone else.
NOTICE
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is
one of continual development and improvement. For this reason, SECO-LARM reserves the right to change specifications without
notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2012 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part,
without the written permission of SECO-LARM.
SECO-LARM
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999
Website: www.seco-larm.com
E-mail: [email protected]
Receiver LED never turns ON and the buzzer never
sounds
 Test the power and ground wire with a voltage meter to
ensure power is connected and is of the correct voltage
Buzzer does not sound if the sensor is triggered
 If jumper J1 is plugged in, this indicates that the beams are
not aligned
 If jumper J1 is not plugged in, buzzer should never sound
Receiver LED is ON and the buzzer sounds all the
time
 Realign the transmitter and receiver
Does not trigger when beam is broken
 Remount the curtain sensor, or repaint the surface to cut
down on reflection
 Lower the response time (SW1)
Receiver continuously triggers the alarm
 Realign the transmitter and receiver
 Check that the tamper switch and the cover for the tamper
switch are mounted correctly
False alarm
 Reinstall so that one sensor does not interfere with another
sensor
 Cut back on leafy vegetation
 Do not mount under the edge of the roof
 Mount under a roof or shelter
Troubleshooting:
Also Available from SECO-LARM:
Curtain Beam
Sensors
Dual Beam
Sensors
Retro-Reflective
Beam Sensors
Quad Beam
Sensors