Controlled Products Systems Group DSP-10LV - Manual

DSP-10 Vehicle Detector
The Only Loop Detector You Will Ever Need!
FEATURES
Loop Size - Works on any in-ground inductive loop from 20 to 1000
uH.
Fail Safe or Fail Secure Operation - Can be easily changed to
either mode in the field.
Power Brownout Call Memory – Power interruptions of short
duration are ignored. If power fails for approximately three seconds
or less the DSP-10 “remembers” a vehicle.
Intelligent Power Protection – The DSP-10-LV is protected from
damage if plugged into a higher voltage. No need to change a fuse
or reset a circuit breaker, simply plug the detector into the proper
voltage and it works.
Indicators - Separate Power/Fail and Detect LEDs.
Compact Size - Industry standard 11 pin connector in a small
plastic case.
FRONT PANEL SELECTABLE SWITCHES
Sensitivity - Ten sensitivity settings.
Frequency – Automatically tunes within one of four operating
ranges.
Outputs - Two separate relay outputs with features that are front
panel programmable as follows:
Output A - Main detection output. Can be modified by
delay and extension. Factory set to be fail safe. Fail
mode operation is easily changeable by internal jumpers.
Output B - Can be set to one of the following:
1) True presence (no extension or delay)
2) Pulse on vehicle entering loop
3) Pulse on vehicle exiting loop
4) Loop Fail output
Sensitivity Boost - Can be used in special applications to insure
complete detection of high-bed vehicles.
Hold time - Normal or extended hold time is selectable.
Loop failure - If the loop fails (opens or shorts) the power indicator
flashes. Output B can also indicate this condition if desired (see
above). The option to "remember" an intermittent loop failure is
also provided.
Delay - Can be selected to ignore fast moving vehicles over the
loop.
Extension - Extends a call for slow moving vehicles.
OPERATION
The DSP-10 vehicle detector has been specifically designed to
handle all parking, drive-through and access control applications.
Working on virtually any size loop, the DSP-10 automatically tunes
itself to the best operating frequency. Environmental conditions are
constantly compensated with the DSP-10’s HYPERTRACK
software. The DSP-10’s inherent noise filtering algorithms allow it
to work reliably in any electrical situation.
It can be used as either a safety loop or free exit loop detector.
With the flexibility to be either “fail safe” or “fail secure,” it is the only
parking detector you will ever need.
The DSP-10 is available in three voltage ranges:
DSP-10-LV 10 to 30 Volts, AC or DC
DSP-10-117 117 Volts AC
DSP-10-230 230 Volts AC
With its compact size, front panel switch features, and built-in
flexibility the DSP-10 is the most “user friendly” detector on the
market today.
Phone: (866) 395-6677 (Toll Free)
DSP10_CUT_U
Web Site: www.diablocontrols.com