Controlled Products Systems Group E-9643-4B190Q - Manual (Page 3)

ENFORCER Long-Range Barrier Sensors
SECO-LARM U.S.A., Inc. 3
Features:
Specifications:
Model E-9626-2B190Q E-9643-4B190Q E-9661-6B190Q E-9679-8B190Q
Number of beams 2 pairs 4 pairs 6 pairs 8 pairs
Max. range (outdoor) 190’ (60m)
Max. range (indoor) 380’ (120m)
Tx standby & active current,
heater off
(+/-25%@12VDC)
56mA 84mA 100mA 109mA
Rx standby current (buzzer
off),heater off
(+/-25%@12VDC)
66mA 80mA 95mA 108mA
Rx trigger current (buzzer on)
heater off (+/-25%@12VDC)
66mA 80mA 95mA 108mA
Buzzer active current (Rx only) 20mA@12VDC
Heater active current (Rx+Tx) 160mA@12VDC
Input voltage 12~24 VDC
Response time (receiver) 150/300/450/600 ms (DIP switch programmable)
Detection methods
Triggers as programmed when any 2 adjacent pair of beams are broken, or any
single pair of beams is broken for over 2 sec. (programmable by JP2)
Selectable beam frequencies 4 Different frequencies (DIP switch programmable)
Alarm output NO/NC/COM, relay output, active for 1 sec. when triggered
Tamper output (Tx & Rx) 1A@120VAC / 1A@24VDC
Alignment LED (Rx only) Red LED, ON – beam is broken / OFF – aligned
Alignment angle Horizontal +/-90 O
Operating temperature -45 O C~55 O C (-49 O F~131 O F)
Humidity 95%
Ingress protection IP65
Case Aluminum housing / PC anti-UV cover / ABS end caps
Dimensions See page 4, Dimensions for more details
Weight (Tx & Rx) with brackets 5.5lb (2.5kg) 7.7lb (3.5kg) 12.1lb (5.5kg) 14.3lb (6.5kg)
For indoor or outdoor perimeter security
Long sensor range up to 190ft (60m)
outdoors, 380ft (120m) indoors
Install on windows, doorways, skylights,
fence tops, and any place where space
is limited
End caps swivel so sensor can be
mounted on a single wall or on opposite
walls with no L-bracket needed
Programmable immediate trigger on
simultaneous breaking of beams, or trigger
after a single pair of beams is broken for at
least 2 seconds
Heater for use in cold weather operation
Heater activates at 41°F (5°C)
Terminal block wiring
Slim design: 2 1 /
4
” x 1 7 /
8
” (55 x 49 mm)
Rugged aluminum construction
Built-in tamper switches, one on either end,
trigger the alarm if end cap is removed
No synchronizing wires required to align the
beams
Form C relay output
LED and buzzer alignment indicators
AGC (Auto Gain Control) circuits regulate
beam signals in order to compensate for
and ensure operation in rain, fog, and low-
temperature conditions
Programmable for 4 different frequencies to
reduce interference between
multiple units