Controlled Products Systems Group E-9643-4B190Q - Manual (Page 2)

ENFORCER Long-Range Barrier Sensors
2 SECO-LARM U.S.A., Inc.
Table of Contents:
Introduction:
ENFORCER Long-Range Barrier Sensors are ideal for protecting indoor or outdoor areas
separated by long distances. They feature reliable photobeam technology with a choice of
four programmable beam frequencies that provide superior perimeter protection by
eliminating crosstalk and interference when multiple units are used. False alarms caused
by animals, falling leaves, poor weather, or other sources are minimized by programming
the alarm output trigger operation.
ENFORCER Long-Range Barrier Sensors work in even the most extreme conditions. A
built-in heater automatically turns on and off depending on the outside temperature. An
environmental control system senses a slow degradation in beam strength when weather
conditions worsen to help prevent false alarms.
Installation and alignment is quick and easy with the ENFORCER Long-Range Barrier
Sensors. They come with swiveling heads that allow them to be mounted along the same
wall or on opposite walls, as well as provide for easy alignment of the beams between the
transmitter and receiver.
Parts List:
Introduction ............................................ 2
Parts List ................................................ 2
Features ................................................. 3
Specifications ......................................... 3
Dimensions ............................................ 4
Swivel Housing ....................................... 4
Sample Applications ............................... 4
Overview – Inside the Sensor ................ 5
Installation – Choosing a Location ......... 6
Installation – Wall vs. Pole Mounting ...... 7
Connecting Multiple Units ...................... 7
Installation – Running the Wires ............ 8
Installation – Mounting .......................... 8
Installation – Connecting the Wires ....... 9
Aligning the Beams .............................. 10
Programming the Trigger Mode ........... 10
Programming the Barrier Sensor ......... 11
Triggering the Barrier Sensor ............... 11
Troubleshooting ................................... 12
1 x Transmitter
1 x Receiver
1 x Manual
4 x Pole mount brackets
8 x Machine screws 4x6mm (for pole mount brackets)
8 x Machine screws 4x25mm (for pole mount brackets)
12 x Screws 6x20mm (for wall mount use)
12 x Plastic anchors (for wall mount use)