Controlled Products Systems Group HCT5011O3-08 - Manual (Page 12)

MOUNTING AND WIRING OF RESET SWITCH
1. Disconnect power to the operator.
2. Mount reset switch at a minimum of 6' away from the gate jambs (Figure 1).
3. Plug the interface cable (Figure 2) into the J5 receptacle on the Omni control
board (Figure 3).
4. Connect like wires from the reset switch to the interface cable. Twist together with wire
nuts.
NOTE: The wire connecting the interface cable to the reset switch is not provided.
STEP 7
Figure 1
DC-BACKUP
J5
FIRE
DEPT.
1 3
STRIKE
OPEN
RADIO
RECEIVER
TIMER SYSTEM ON
EXIT
LOOP
ALARM SENSOR REVERSE SENSOR OPEN
ST
OP
CLOSE SAFETY
LOOP
CENTER
LOOP
GATE
LOCKED
60 POWER
OVERLOAD
OFF
OPEN LEFT
DC-BACKUP
ALARM
SENSOR
OPEN RIGHT
3 SENSORS
RESET
MOTOR
1 3
1 3
COMMAND PROCESSED
ON
MADE IN USA
Plug Reset
Switch Connector
to J5 Connector
Figure 3
Figure 2
The reset switch allows the operator to
be reset upon the event of a double
entrapment alarm. When such an event
occurs the alarm will continuously
sound and the operator will not have
any functionality until the board is reset.
WARNING WARNING
To prevent possible SERIOUS INJURY or
DEATH from electrocution, disconnect
electric power to operator BEFORE
installing.
ALL electrical connections MUST be
made by a qualified individual.
RESET
RESET
6' min.
10