Controlled Products Systems Group 800IOL - Manual (Page 4)

BYAN SYSTEMS, INC.
Automated Gate and Access Control Products
413 Linden • Lusk, WY 82225 • (800) 223-2926
3
800A/900A SERIES TECHNICAL DATA
MODEL 800A: 220 VAC SINGLE PHASE
MODEL 900B: 115 VAC SINGLE PHASE
ELIMINATOR SERIES BUILT-IN THERMAL OVERLOAD
CAPACITOR
RATING: 10UF FOR THE 800A
35UF FOR THE 900A
STANDARD
WORKING PRESSURE: 1350 PSI
MAXIMUM WORKING PRESSURE: 1750 PSI
PUMP:
SPUR GEAR 1.0 LTR/MIN.
MOTOR:
1/6 HORSE POWER
OPERATOR LENGTH WITH PISTON
754 TO 904 MILLIMETERS
RETRACTED AND REAR BRACKET AND 29-11/16 TO 35-5/8 INCHES
SWIVEL INSTALLED
OPERATOR LENGTH EXTENDED WITH REAR
1004 TO 1304 MILLIMETERS
BRACKET AND SWIVEL JOIN INSTALLED 39 TO 51 5/16 INCHES
OPERATOR
WIDTH: 3-3/8 X 3-3/8 INCHES
4-5/16 WITH LOCK
OPERATOR SPEED TO 90 DEGREES:
13 SEC. FOR 800A
13 SEC. FOR 900A
PISTON
STROKE: 250 MM OR 9-7/8 INCHES
400 MM OR 15-3/4 INCHES
AMBIENT OPERATOR TEMPERATURE RANGE: -60 TO 220 DEGREES F
HYDRAULIC
FLUID: SHELL TELLUS T-15
THIS PATENTED NEW CONCEPT IN LINEAR ACTUATOR DESIGN ELIMINATES THE NEED
FOR PHYSICAL STOPS. THE VALVE DESIGN CUSHIONS THE LAST HALF INCH OR ABOUT
THE LAST 5 TO 10 DEGREES OF PISTON TRAVEL ALLOWING THE PISTON TO REACH END
OF STROKE IN BOTH DIRECTIONS AND PREVENT INTERNAL DAMAGES.
OPERATOR BODY FABRICATED IN ANODIZED ALUMINUM
FRONT AND REAR FLANGES ARE CAST ALUMINUM
ALL INTERNAL COMPONENTS ARE CAST AND MACHINED
INTERNAL COMPONENTS BATHED IN OIL SO VIRTUALLY NO MAINTENANCE REQUIRED.