Controlled Products Systems Group 3950 - Manual (Page 19)

19
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor
unit until the learn indicator light goes out
(approximately 6-9 seconds).
All previous codes are now erased.
Reprogram each remote or keyless entry you
wish to use.
To Add or Program a Hand-held Remote Control (Not Provided)
Below are instructions for programming your operator to operate with optional Security✚ ® remote controls. A maximum of eight
Security✚ ® remote controls can be programmed to work with your operator.
1. Press and release the purple “learn”
button on the motor unit. The learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your door.
3. Release the button when the learn
indicator light blinks and shuts off upon
learning the remote control. If the
optional remote light is installed, the
light will blink.
PROGRAMMING
NOTICE: If this Security✚ ® door operator is operated with a non-rolling code transmitter, the technical measure in the receiver of the
door operator, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the door
operator does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical measure.
4. If the safety reversing sensors are not installed or misaligned,
the door will not close from a hand-held remote control. If this
occurs, the door can be closed by pressing and holding the
push button on the single button control station until the door
has closed. Releasing the push button prior to the door closing
will cause the door to reverse.
USING THE “LEARN” BUTTON