Chapin 61500 - Manual (Page 2)

1E
• PRE-USE CHECK: Before each use check tightness of hose nut to be sure hose is
securely attached to the shut-off assembly. Insure hose is securely attached to the
pump outlet by tightening hose nut. Insure that all nozzle and wand connections are
tight. Insure the three bolts (underside of base) used to attach the piston cylinder are
tight.
• Do Not exceed a tank solution temperature of 120º F/ 49º C.
NOTE: The tank and hose may have residual water in it due to quality testing
performed on the sprayer.
WARNING: Handling the brass parts of this product will expose you to lead, a chemical
known to the State of California to cause birth defects and other reproductive harm.
Wash hands after handling.
6-8096
Buse en
éventail plat
6-8093
Buse poly
ajustable
6-8148
Trousse de
buse
Écrou de
blocage
Joint
d’étanchéité
de buse
Coude avec
joint torique
10F
INFORMATION DE COMMANDE DE PIÈCES DE RECHANGE
6-8120B
Vanne d’arrêt
Trousse de réparation
Capuchon
vissé
Joint
torique
6-8101
Assemblage
des tubes
Tube
6-8138
Assemblage
d’arrêt
6-8202
Assemblage
du boyau
Rondelle
de boyau
Écrou de
blocage
Boyau
6-8209
Assemblage de bras
de raccordement
6-8193
Poignée de la pompe
avec pince
6-8122
Buse de
laiton
ajustable
WARNING
CAUTION
WARNING: Improper use or failure to follow instructions can result in explosive
failure causing serious eye or other injury. For safe use of this product you must read
and follow all instructions. Do not leave a pressurized sprayer in the hot sun. Heat can cause
pressure build-up resulting in possible explosion. Do not store or leave solution in tank after
use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when
spraying. Never use any tool to remove pump if there is pressure in the pressure chamber.
Never pressurize sprayer by any means other than the original pump. Do not attempt to
modify this sprayer. Replace parts only with manufacturer’s original parts. Never spray
flammable, caustic, acidic, chlorine, bleach or other corrosive solutions or
heat, pressure, or gas producing chemicals. Always read and follow chemical
manufacturer’s instructions before use with this sprayer as some chemicals
may be hazardous when used with this sprayer.
SK 1158-1