Chapin 22090 - Manual

WARNING!
Printed in U.S.A.
1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.
2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of
these conditions are found, replace hose before using. Replace with original manufacturer’s
parts only.
3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and
exterior of tank for signs of deterioration of body and bottom. Any sign of deterioration
indicates possible tank weakening and could result in explosive bursting under pressure. If any
of these signs are found, discard tank immediately and replace. Do not attempt to patch leaks,
etc., as this could result in serious injury.
4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only.
5) Do: Pump plunger 8-10 strokes and inspect for leaks.
6) Do: Direct shut-off away from you and open to make sure discharge is not clogged.
7) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank,
and proceed with Filling, Pressurizing and Spraying Instructions.
3. Pre-Use Check
4. Filling
1) Do: Turn pump handle counterclockwise and remove pump
2) Do: Prepare spray solution following all directions and safety warnings on chemical label.
3) Do: Fill tank to no more than the proper gallon marker. Do NOT: over fill to
accommodate pump.
4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in
tank and tighten securely.
5. Pressurizing and Spraying
Do: Turn handle clock-
wise to tighten. Push
handle down, turn 1/4
turn counterclockwise to
release.
Do: Pump until
you feel resistance.
Do: Push handle,
down, turn 1/4 turn
clockwise to lock. Be-
gin spraying. Re-pump
sprayer as required to
maintain spray force.
7. To Release Pressure
1) Your sprayer is equipped with a pressure relief/release valve.
To release pressure lift and hold the cap until air is completely
exhausted, OR, turn the valve slowly counterclockwise until you
hear air escaping and wait air is completely exhausted.
2) Do: Stay away from the sprayer until all air has escaped.
8. Care, Storage and Maintenance
1) Do: Rinse tank thoroughly with water only, empty, refill with water. Follow Filling,
Pressurizing and Spraying Instructions, except pump unit only 8-10 strokes.
2) Do: Open shut-off and allow water to run through discharge assembly.
3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty
sprayer.
4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.
5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through
opening in cover.
010538 (A) R0209
5A 5C
1. Hose to Tank
5B
Make sure white out-
let tube is attached to
hose.
Insert tube into
tank.
Parts
WARNING: Handling the brass parts of this product will expose you
to lead, a chemical known to the State of California to cause birth
defects and other reproductive harm. Wash hands after handling.
2. Nozzle
Attach nozzle to extension wand.
1A 1B
Proper placement of
white outlet tube.
1C
Line up tabs on safety
lock connector with
notches on the outlet
flange of the tank. Insert
tabs into notches to
form a secure seal.
4
1D
Slip hose nut down to
tank, turnclockwise and
tighten as tight as possible
by hand.
1E
Hazard: Improper use or failure to follow instructions can result in explosive failure causing
serious eye or other injury. For safe use of this product you must read and follow all instructions.
Do not leave a pressurized sprayer in the hot sun. Heat can cause pressure build-up. Do not store
or le ave solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants and full
foot protection when spraying. Never use any tool to remove pump if there is pressure in sprayer.
Never stand with face or body over top of tank when pumping or loosening pump to prevent eject-
ing pump assembly and/or solution from striking and injuring you. Never pressurize sprayer by any
means other than the original pump. Do not attempt to modify or repair this product except with
original manufacturer’s parts. Never spray flammable materials or heat, pressure, or gas produc-
ing chemicals. Always read and follow manufacturer’s instructions before use with this sprayer
as some chemicals may be hazardous when used with this sprayer.
Sk-1113-1
6-6136
Hose
Manguera
Tuyau
6-7742
Extension wand, Vara de extensión, Rallonge
6-1898
Shut-off Handle
Mango de cierre
Poignée du robinet
6-3337
Straps
Tirantes
Sangles
For constant spraying, push down on shut-off
handle and move locking mechanism away
from you. To release, squeeze handle and
move the locking mechanism back towards
you.
6. Fatigue-Free Spraying
2A
Note: Your particular sprayer may not include all parts pictured above.
Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.
Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.
6-5797
Nozzle .5GPM
Tobera
Buse
Polyethylene
Wide Mouth Sprayer
Pulverizador de polietileno
de boca ancha
Pulvériateur en polyéthyl
è ne
à grande ouverture
P.O. Box 549 700 Ellicott St.
Batavia, NY 14021-0549 U.S.A.
1-800-950-4458 www.chapinmfg.com