INSTEON ToggleLinc Dimmer (2466DW) Manual - Manual (Page 19)

Page 19 of 20 Rev: 1/21/2014 7:34 AM
reset. See Factory Reset.
ToggleLinc is getting
warm to the touch. It is normal for wall dimmers to
feel warm, but not hot.
ToggleLinc Dimmer will dissipate about 1W per
100W controlled. Using metal junction boxes,
removing insulation around the box or
controlling a smaller load can lessen the heat.
ToggleLinc can turn off
my responder, but
nothing happens when I
send an ON command
from ToggleLinc.
Your responder may be linked
at its off state. Relink your responder to ToggleLinc, while the
responding device is on.
My controller can turn off
ToggleLinc, but
ToggleLinc does not turn
on when I send an ON
command from my
controller.
ToggleLinc may be linked at
its off state. Relink ToggleLinc to your controller, while the
load is on.
After wiring in
ToggleLinc, the unit lets
out a continuous beep. ToggleLinc is issuing an error
beep because the unit is wired
incorrectly.
Turn off the circuit breaker and try reinstalling
ToggleLinc. If you are still experiencing an
error beep, consult an electrician to help you
install ToggleLinc.
If you have tried these solutions, reviewed this Owner's Manual, and still cannot resolve an issue you are
having with ToggleLinc Dimmer, please call the INSTEON Support Line at 1-800-762-7845.