INSTEON ToggleLinc Dimmer (2466DW) Manual - Manual (Page 12)

Page 12 of 20 Rev: 1/21/2014 7:34 AM
Status LED will continue blinking.
You will have 4 minutes to complete the next step before unlinking mode times out.
3) Press and hold the responder’s Set button for 3 seconds.
ToggleLinc will double-beep and its LED will stop blinking
4) Confirm that unlinking was successful by tapping ToggleLinc’s toggle on and off.
The responder will no longer respond.
Adding ToggleLinc Dimmer as an INSTEON Responder
Follow the steps below to make ToggleLinc a responder of another INSTEON controller.
1) Press and hold the controller’s Set or scene button until it beeps and/or LED blinks (about 3
seconds).
If the controller is a multi-scene device such as a KeypadLinc, press and hold the scene button
you want to use as the controller.
Controller’s LED will blink.
You will have 4 minutes to complete the next step before linking mode times out.
2) Use ToggleLinc to set the connected load to the state you want to activate from the controller (e.g.,
on, 50% brightness, off).
3) Press and hold ToggleLinc’s Set button until it double-beeps (about 3 seconds).
ToggleLinc’s status LED will flash.
4) Confirm that linking was successful by tapping the controller button on and off.
The load connected to ToggleLinc will respond appropriately.
Removing ToggleLinc Dimmer as an INSTEON Responder
If you are going to disable or remove ToggleLinc Dimmer, it is very important that you unlink it from all
controllers. Otherwise, the controllers will try sending commands to ToggleLinc, causing delays in your
INSTEON network’s inter-device communication.
1) Press and hold the controller’s Set or scene button until it beeps and/or LED blinks (about 3
seconds).
Controller’s LED will blink.
2) Again, press and hold the controller’s Set or scene button until it beeps and/or LED blinks (about 3
seconds).
Controller’s LED will continue blinking
You will have 4 minutes to complete the next step before unlinking mode times out.
3) Press and hold ToggleLinc’s Set button until it double-beeps.
ToggleLinc’s status LED will flash.
4) Confirm that unlinking was successful by tapping the controller button on and off.
The load connected to ToggleLinc will no longer respond.
Creating INSTEON Scenes
INSTEON scenes let you activate dramatic room ambiences with multiple lights and appliances. For
example, you can set all the lights in a scene to dim to 50% or turn certain lights on while turning others
off, all with the tap of a button on a controller.
INSTEON scenes are very easy to set up: just link more than one responder to the same On/Off or scene
button on a controller. Then, when you press any of the linked buttons on the controller, all of the
INSTEON devices linked in the scene will respond as a group.
To set up an INSTEON scene, you can individually link each device to a controller. Or save time and
create multiple links at once.