INSTEON On/Off Module - 2633-422 (France), 2633-432 (Germany), 2633-442 (UK), 2633-522 (AUS/NZ) Quick Start - Manual

2633-422/2633-432/2633-442/2633-522 Rev. 11/28/2012 3:00 PM / See Owner’s Manual for warranty information.
Protected under U.S. and foreign patents (see www.insteon.com)
© Copyright 2012 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 866-243-8022
Quick Start Guide
INSTEON ® On/Off Module
Models: 2633-422, 2633-432, 2633-442, 2633-522
Install INSTEON On/Off Module
1) Turn on lamp or appliance
2) Unplug
lamp/appliance and plug it into On/Off Module receptacle
3) Plug On/Off Module into unswitched wall outlet
Load will turn on and On/Off Module LED will turn on green
Make On/Off Module a Responder
1) Press and hold controller button until it beeps
Controller LED will start blinking
2) Tap On/Off Module on (or off if you want the load to turn off when the scene is
activated)
3) Press and hold On/Off Module set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off
Connected load will return to the state set in step #2
Assign an X10 Address
1)
Press and hold On/Off Module set button until it beeps
On/Off Module LED will start blinking green
2) Send the X10 address 3 times (with or without commands)
Example: A1-A1-A1-AON or A1-AON-A1-AON-A1-AON
On/Off Module will double-beep and its LED will stop blinking
3) Test by sending X10 on and off commands
Load will turn on and off
Owner’s Manual and Tech Support
Visit: http://www.insteon.com/support for complete manual, online tech support and latest product documents.
Call: INSTEON Support Line at 866-243-8022
2633-442
(UK)
Paddle top
(on)
2633-422
(France)
2633-432
(Germany)
2633-522
(Aus/NZ)
LED
Paddle bottom
(off)
Set button